A blog about finding and keeping my 1973 Mustang Grande (V8 - 351C 2V). Produced on July 6, 1973. Sold in Florida, USA.

Tuesday, September 16, 2014

Taking out the instrument cluster

So, recently my car passed its bi-annual checkup (required by law in The Netherlands) without any problems. However, my turning indicators don't work anymore which is very annoying because after making a turn I can't see if my indicator is still on and thanks to the lovely sound of the 351C, I can't hear the clicking of the relay either. So I figured I'd spend a bit more time in fixing that quickly.

I'm slowly starting to realise that my life is not a car show on Discovery and that there is actually no such thing as "quickly" when it comes to doing my own repairs ;-)

So above there's a picture of the instrument panel. Behind it is the instrument cluster. Let's try to open it...

Unscrewing 4 screws to losen the panel is easy however, you do need to remove the side panel as well. Depending on how far your car door will open, this is a pain sometimes because you can't reach the screw very well.

When the panels are removed, you get to see the actual instrument cluster. This is also held in place by four screws, easily accessible.

What's not very easy is disconnecting the wiring and the speedometer cable. Not because they're so stuck but because they are difficult to reach.Also, the alternator light was not just a light screwed in to the back as all the others, but it's attached to a big cable running behind. So do not rip it out once the big connector and the speedometer cable have been disconnected because you're not done yet! Disconnect the alternator light seperately!

And then you find out the steering wheel needs to be removed to take the cluser home for the neccesary repairs...

So I screwed back the losened cluster in order to remove the wheel.

Unscrew the horn-pad from behind.

The steering wheel didn't let go. I was advised to just hit it from behind firmly but after 3 attempts I gave up because it felt wrong. It's not how I like to work so I ordered a steering wheel-puller. This made the job easy.

I also removed some trim around the steering column for better access.

And then I had a big hole in my dash... On the right side you can see the electric connector and the speedometer cable.

This is the seperately wired alternator light. I have no idea why it's wired seperately as the printed circuit has a place for a normal light fitting...

One instrument cluster removed, thank you very much.

I took the instrument cluster home to work on. Here you can see the old printed circuit. I found out that the light for the fuel gauge is simply missing... On the right you can see the hole where the alternator light goes.

The reason my indicator light wasn't working. I have ordered new parts. Now we wait...

To be continued.

No comments:

Post a Comment